Vw Passat B6 Door Lock Module Removal

Remove those two m8 bolts from the door lock module.

Vw passat b6 door lock module removal.

Remove the t30 torx bolts from the low side of the door. The module is held to the case with three clips. All of the usual door slamming solutions have now stopped working so i have decided to replace the cable. Front left door lock cylinder key for vw volkswagen passat 1997 2005 fits.

They should snap off rather easily. After these are removed the module and case should come free from the door. Remove the plastic cover from the door lock module. Volkswagen passat 3 5 out of 5 stars 12 12 product ratings front left door lock cylinder key for vw volkswagen passat 1997 2005.

Remove all t30 torx bolts. Disconnect these clips and pull the module out of the case. Remove the door lock module and take the cable out. Remove the door foam from the left side to have acces on the door lock module 6.

Rate comment share subscribe. Unscrew these from the side of the door where the lock is situated and it should then come straight out. When where needed. To release the module you will need to remove the 2 triple square bolts from the rear side of the door.

Remove the door handle 9. Remove the purple rubber band. Take that part out from the door 10. Removing the internal door panel was straightforward but now i have come to the point where i need to remove the door lock handle in order to remove the internal metal trim to access the cable.

Remove the handle. With the door open here is a view of what the door should look like with the metal panel removed and the a lock in place. To remove the lock itself there are another two screws holding it to the door. Hi folks i have the classic bowden cable fault on the front passenger door on my b6 passat.

Removing the internal door panel was straightforward but now i have come to the point where i need to remove the door lock handle in order to. All of the usual door slamming solutions have now stopped working so i have decided to replace the cable. Remove the door lock mechanism and disconnect the cables and the blue hose. Remove those three bolts from the door lock module using a t30 torx 7.

Raise support the vehicle safely according to manufacturer jacking supporting positions.